Adhesive-Friendly Design - Part 2
Structural bonding has many advantages over conventional joining technologies. However, adhesives should be considered early on in the design phase to take full advantage of their potential. The first part of this article was about how to ideally utilize these possibilities with a tongue and groove connection. The second and last part introduces further design options.
While tongue and groove is a reliable and widely used method to ensure solid structural bonding, it is not feasible when bonding thin metal sheets. However, there are several other options available. If the materials are formable, bending the components and placing them one on top of the other will improve the bond strength, as this will significantly increase the bonding area. Although more complex, as it involves additional process steps, this is an excellent option where higher strength is required (figure 1).
The strength of a pipe joint leaves much to be desired if the two components are bonded at their ends (figure 2). Adding an additional interior or exterior ring enlarges the bonding area tremendously and decreases the risk of bending stress. The two components can also be overlapped by adapting the diameter of one. Because of the adhesive's sealing properties, liquids can easily flow through these pipe joints without leaking.

Simple Steps for Adhesion Success
A correctly dimensioned bonding gap is extremely important when engineering an adhesive-friendly design. It ensures a consistent adhesive layer thickness, which enables the adhesive to fully develop its adhesion forces. It can be provided by a defined contact area with spacers integrated into the components being bonded, or by a tongue and groove joint. If the gap is too narrow, the components press the adhesive out and the bond will not hold.
Advantages of bonding
- Different materials can be joined
- Tension is evenly distributed
- Components are not weakened, e. g. by boreholes
- High resistance to dynamic forces
- Laminar joining of thin components
- Components are not or are only slightly subjected to heat
- Simultaneous bonding and sealing is possible
- The adhesive layer balances tolerances
- Electrically or thermally conductive adhesives are available
8 rules for design engineers
- Provide sufficiently large bonding areas and gaps
- Achieve evenly distributed tensions
- Limit stress to compression, tension and shear stress if possible
- Avoid peel and bending stress
- Avoid eccentric force transmission
- Prevent plastic component deformation
- Provide adhesive-friendly surfaces
- Comply with the curing conditions required by the adhesive
Further design options can be found in part 1.
Do you have any questions?